• 6.4 Volt
• Rated 1500 Charge Cycles
• Tested to EN62133 and UN DOT
• Very low self-discharge
• Direct plug connection to board
• PTC’s integral to battery
• Crimper can operate while battery is charging.

Motor: Stall torque 1400 g cm.

Control Buttons: Top-mounted keypad – equal visibility and convenience for left- and right handed use.

Compliance: Safety: Machinery Directive and EN/IEC 61010 EMC: IEC 61326-1:2006

Electronics: 20 MHz processor with A/D measurement of battery voltage and motor current. Advanced charging circuit. Additional on-board safety circuitry. PWM for soft-start of motor.